Installation Size Considerations

Verify that the selected installation location provides sufficient space for the corrector and meter. Also allow additional space for any attached devices, if applicable.
Leave sufficient space around the corrector and meter to allow access to the display, AMI/AMR device, pressure piping, antenna for modem communication, and cable access for testing, as applicable.

>> View dimensional drawings and specifications

Environmental Considerations

The MC3 may be operated within the following ranges:

• Temperature: -40°F to 140°F (-40°C to 60°C)
• Humidity: 0–95% (condensing)
  EMC EN61000-4-2, Severity Level
  EN 61000-4-3, Severity Level 3
  Meets FCC class B requirements

• Ingress: IP66 and NEMA 4X for dust and water penetration

Verify that the location where the corrector and meter are installed will remain within these ranges.

Ensure the corrector and meter can remain level within 1/16 inch per foot (5 mm/m) in any direction, side to side, and front to back.

Safety Considerations

Safety considerations, certification standards and safety requirements coming soon.

Magnetic Shaft Swap

The MC3 has a magnetic shaft that senses volume from the meter. It is shipped with the magnetic shaft inserted in the 2/3/5M 23/38/56M port by default. Follow the video instructions to change the location of the magnetic shaft to accommodate different meter sizes.

Install Corrector onto Meter

Changing Corrector Orientation

See how to change your MC3 from top to side inlet orientation.

Waking up the MC3 With Magnet Swipe

This video shows you how to use a magnet to wake up the MC3.

Waking up the MC3 Using a Mobile Phone With NFC

Perform the following steps to wake up the MC3 using a mobile phone equipped with NFC.

Modem Installation

Learn how to install a modem to the MC3.

Installing an Antenna

Watch how to install an external antenna to the MC3 in our video guide.

External Pressure Transducer Installation

Perform the following steps to install the external line pressure transducer.

Differential Pressure Piping Installation

For the MC3 Guardian, differential pressure piping needs to be installed to monitor differential pressure. Watch the following video for more information.

Wiring instructions for hazardous locations

Check back for more information.

Pulse Output Cable Guide

>> Download the PDF file

Internal Temperature Probe Replacement

Replace internal temperature probe.

External Temperature Probe Replacement

Replace external temperature probe.

Temperature Probe Calibration

Check back for more information.

Internal Pressure Transducer Replacement

Internal pressure transducer replacement.

External Pressure Transducer Replacement

External pressure transducer replacement.

Pressure Transducer Calibration

Check back for more information.

Battery Maintenance and Replacement

Maintain and replace communication or metrology batteries.